Optoma Technology Single Chip DLP Projector Manual de usuario descargar pdf (Pagina 11)

English

Installation

Powering Off the Projector

1. Press the Power/Standby button to turn off the projector

lamp.

2. After pressing the Power/Standby button, you will see a

message Power off the lamp? on the on-screen display.

Press the Power/Standby button again to confirm. Other

wise the message will disappear after 5 seconds.

3. Power/Standby indicator flashes red for about 2 minutes.

The projector will automatically shut itself down.

If you want to turn on the projector, you must press the

Power/Standbybutton within 2 minutes of the start of the

indicator flashing.

4. Disconnect the power cord from the electrical outlet and the

projector.

5. Do not turn on the projector immediately following a power

off procedure.

v When the TEMP indicator flashes red for about 10 seconds, you

will see a message Fan Fail on the on-screen display. After 5

seconds, the Power/Standby indicator flashes green for about 2

minutes and the projector will automatically shut itself down.

Please contact your local reseller or service center.

v When the TEMP indicator lights solid red for about 10 seconds,

it indicates the projector has been overheated. You will see a

message Over Temperature on the on-screen display. After 5

seconds, the Power/Standby indicator flashes green for about 2

minutes and the projector will automatically shut itself down.

Please contact your local reseller or service center.

v When the LAMP indicator lights solid orange and Power/

Standby indicator flashes green for about 2 minutes. The projec-

tor will automatically shut itself down. Please contact your local

reseller or service center.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Sin comentarios

Optoma Technology Single Chip DLP Projector Manual de usuario Pagina 11